精密工学会誌 = Journal of the Japan Society for Precision Engineering
巻
81
号
10
ページ
974 - 978
発行年
2015-01-01
ISSN
0912-0289
NCID
AN1003250X
DOI
10.2493/jjspe.81.974
出版者
精密工学会 = The Japan Society for Precision Engineering
抄録
This study deals with a novel generation method of tool paths in a main-processor of a CAM. Currently, some tool path generation methods such as contouring path, scanning path, spiral path and constant scallop height path are installed in several CAM applications. However, since these tool paths are generated by differential operations and convergence calculations, complex branches on conditions are required, and the operation is unstable behavior at extremum neighborhood. It still threatens to cause clash of the operation. Therefore, two parameters (u, v) composing a machined surface are the focus of this study. In our proposed method, machining points are calculated on a plane constructed by the parameters. Then, since the calculation is executed in response to the real space, a homogeneous tool path is obtained. By using our proposed method, it is possible to generate tool paths quickly and effectively without the extremum problem and complex branches on conditions. This paper explains the particulars of our proposed method and the implementation method for two spiral paths. Finally, the effectiveness of our method is confirmed with machined workpieces.
曲面パラメータに基づいた高精度高効率工具経路生成: 一般曲線への適用
.png)
TE-PR-TAKASUGI-K-974.pdf
(1.99MB)
